Phase-III
 

The KC Board:D 75% done

I saw your post about loud noise. Try taking duct tape and attaching the tape to the board next to the motor. Then run the tap up over the motor and attach the strip of tape to the board on the other side of the motor. This will "tighten" up the fit of the motor to the board. Try pulling the tape tight to insure that motor is like "one" with the board.
Joe

try duct tape
 

Nice.

I saw your post about loud noise. Try taking duct tape and taping down the motor to the board. First take a ~8" strip of the duct tape and press it to the underside of the field, then run the tap up over the motor (tightly) and attach the end of the strip of tape to the board on the other side of the motor. This will "tighten" up the fit of the motor to the board and may give you a touch more vibe and less noise. Try pulling the tape tight to insure that motor is like "one" with the board.
Joe

Thanks Coach
 

thmbsp$