Quote:
|
do you have a tool for tweaking?? if yes, try slightly pulling the prongs first before you use flames on the prongs. you can get more from a base by doing this...not pulling them too hard or long... go slow until you find "your sweet spot".
|
What do you mean by "pulling" ? I grab the prongs with my pliers, and pull ?
Should I grab the top of prong, or the base of it ? I didn't know that tips. Thanks
You're right, with flame it's a non returning back journey
If you go too far..too late. But for speed tweaking, it's the best solution I know.
Quote:
|
When you get into tweaking bases, remember that you need to think about the 'end result' before you start the process on that base.
|
Yes, I try to think about the end result even during the sculpting process of the figure
Powerfull full back for shoprt push, slot receiver, etc, etc...
The difficulty is th achieve the good tweaking for it.