Here are the instructions
Curly Culp.
1. This figure is created from the Freak pose base and the Sprinter’s hands.
2. Cut the upper torso at the waist.
3. Apply super glue and turn the up torso counterclockwise about 10-15 degrees.
4. Spray with the accelerator so that it will stabilize.
5. Cut the left arm at the shoulder pad.
6. Re-orientate the shoulder by applying glue to make the arm extend toward you.
7. Cut the right torso and re-orientate the arm upward.
8. Heat the right arm and pull it out and up.
9. At this point, you can change the hands out with the Sprinter hands.
10. Cut under the left foot at the platform.
11. Heat the right leg at the ankle and raise up where his left leg is off the ground.
|