Face Masks....
Ed,
Be carefull .I was attacked for the very same questions on the
Miggle site.Hope you have better luck than I did.But in answer to
your inquiry,the ones I have are " stiffer" than usual too.It just
takes a little more effort to work them.This is what works for me;
cut them from spru with snips;bend them as best you can around
a paintbrush or something round/hard.I use a stainless steel spatula
my dad had laying around.It is the size (diameter ) of a paint brush.Works
pretty good.Then i take flat-nose pliers and work the outside edges (bend in)
to get a slight bend so they fit the helmet better.
Hope this helps.
SEMPER FI,
Chris Stacey
Hampton,Va.
|