|
#1
|
||||
|
||||
Percentage-based passing
NOTE: Revised tables and better explaination below.
I have played some games using the passing sticks, and while I love the idea, some of my friends that I play against disliked how a defender could hit a hotspot on the board and pick off a short pass from across the field. Also, there was no way to throw curl routes (with the receiver remaining stationary). I am developing a way of using passing sticks and dice to pass with. To start, the offensive coach places a ball using the passing stick. Then, the distance of the nearest defender is measured to the ball. The offensive coach rolls a 20-sided die. Based on how far away the defender is (compared to the offensive player), a certain number or higher equals a completion, and a certain number or lower equals an interception. For example, if a 14 yard passing stick were used, and the defender was 17 yards from the ball target, a roll of 9 or higher would be a completion, and a roll of 1 would be an interception. I have also incorporated bullet passing and curl route techniques. However, this is still a work in progress. I will keep tweaking the numbers (there isn't many stats to go off of for completion % based on distance of throw), and if anyone is interested, I'll post the tables. I realize that this doesn't take each receiver's and defender's speed into account, but I think it will reduce my friends' complaining. Last edited by volcanohead : 09-06-2010 at 12:33 PM. |
#2
|
||||
|
||||
yes!!!!
interested post the tables!!!
|
#3
|
||||
|
||||
Here they are...
revised tables below)
(Note: I use a 20-sided die that came with a Battleball board game, and use 6 different passing sticks: 5, 8, 11, 14, 17, and 20 yards, labled 1-6 respectively. The first number in parenthesis is the minimum roll for a completion; the second number is the maximum roll for an interception. For defender's distance to ball, if the defender is 7 yards from the ball and a 5 yard stick was used, the distance is +2, and so on.) Last edited by volcanohead : 09-06-2010 at 12:29 PM. |
#4
|
||||
|
||||
Bullet passes
For curl routes, just treat the stationary receiver as the ball target and use the nearest defender's distance to the receiver, minus the length of the passing stick that would normally be used (see more detailed explaination below). You can throw either a normal or bullet pass to a stationary receiver as long as you use the correct charts. Remember, these numbers will almost defintely change. If it seems like it is too easy or two hard to complete a pass, I will tweak the numbers to even the balance.
Last edited by volcanohead : 09-06-2010 at 12:32 PM. |
#5
|
||||
|
||||
Bump
Any feedback/ideas would be appreciated.
|
#6
|
||||
|
||||
Revised
I moved the charts, see below.
Last edited by volcanohead : 09-06-2010 at 12:26 PM. |
Thread Tools | |
Display Modes | |
|
|