|
|
|
|
|
#1
03-13-2007, 06:24 PM
|
|||
|
|||
Motor wiring help
Just putting the finishing touches on my first board but am not sure of the best way to wire my motors to the power source and have a cord with the on/off switch (i actually want to wire a cord for each side of the board) any suggestions?
 thanks!
|
|
#2
03-13-2007, 06:39 PM
|
||||
|
||||
|
Contact Kansas Bill. e can tell you exactly what to do.
__________________
EM-F-er [ěm -f-er] –noun-abr-slang: Electric Miniature Footballer 1. a person/hobbyist/gamer who creates a representation of American Football in a small or reduced scale for competition or show. 2. the majority of forum users on the website, www.miniaturefootball.org —Idiom 3. One Bad Em-F-er, negative shout out; pertaining to weirdwolf: There goes one bad EM-F-er. I mean he can’t play and ain’t never win nothin’! 
|
|
#3
03-13-2007, 06:49 PM
|
||||
|
||||
|
You'll need two 3-way switches. Just wire them up as in the pic. You can follow how the board will work by the pics. First pic (upper left) the power flows through switch A and goes over to switch B where it stops. The board is off at this point. By turning switch A on (lower left) or switch B on (upper right) the power completes its loop and the board runs. By switching switch A off (upper left) or switch B off (lower right) the board is off again. Hope this helps.
__________________
West Michigan League of Miniature Football Fantasy football at it's finest!
|
|
#4
03-13-2007, 06:52 PM
|
||||
|
||||
|
Whoops, the pic is cut off at the top. The wire from switch A #1 goes to switch B #2. Just look at the bottom 2 pics!
__________________
West Michigan League of Miniature Football Fantasy football at it's finest!
|
|
#5
03-13-2007, 07:00 PM
|
|||
|
|||
|
Cool thanks for the info!!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
