|
|
|
#1
05-07-2009, 04:59 PM
|
||||
|
||||
Needed information
I need information on what material I need to buy to make shoulder pads, added muscle ect. for figures.
I need to get this from Micheal's or Hobby Lobby ( the only local stores) Please Help 
|
|
#2
05-07-2009, 05:16 PM
|
||||
|
||||
|
Apoxie Sculpt
I seen in other posts Apoxie Sculpt was used to handle this task. There were some examples in the photo gallery forum
|
|
#3
05-07-2009, 05:25 PM
|
||||
|
||||
|
Dry hard clay??
Doug,
I know Micheal's sells 3 or 4 variations of dry hard clay as I checked it out on their website. I am going to buy some tomorrow and try it, therefore I couldn't tell you how well it works or doesn't yet. I got it out of a Scott Hooper post, I believe. I also know from many posts that folks use that epoxy sculpt, however, if I had a solution with out mixing up epoxy, that would be my preference. http://www.michaels.com/art/online/s...%20clay&type=5 I'm sure someone more versed than I will chime in... Regards, Joe Ram
|
|
#4
05-07-2009, 08:14 PM
|
||||
|
||||
|
Joe and philly
Thanks for the information but the store in waco doesnt caring Apoxie Sculpt . I was worried about the clay drying and cracking , so let me know how it goes. Again thanks
|
|
#5
05-07-2009, 09:27 PM
|
||||
|
||||
|
you can order apoxy sculpt. If you're going to do it, do it with some good stuff.
http://www.avesstudio.com/ 1/4 pound of white apoxy sculpt is here: http://www.avesstudio.com/Products/A...ie_sculpt.html
__________________
"Ask not what the MFCA can do for you, but what you can do for the MFCA"
|
|
#6
05-07-2009, 09:37 PM
|
||||
|
||||
|
Thanks Joe
I am on it
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
