Next project on the bench

[btower06]

how can you get the curve on the facemask .no matter how much i try i keep getting the v-shape. some advise on this would helpful. btower06

[Shabby J]

Originally Posted by btower06

how can you get the curve on the facemask .no matter how much i try i keep getting the v-shape. some advise on this would helpful. btower06

I am surprised you have not gotten an answer yet, this has been addressed several times, you take a small rod, dowel, paintbrush handle, etc... approximately the same size as the helmt on the figure, then you roll the mask around the handle of the brush. Use the rounded handle, dowel, etc... to mold the curve into your mask. Search this forum, I think there is even a picture or two showing exactly what I am talking about.