|
|
|
#1
06-11-2009, 10:31 AM
|
||||
|
||||
Got motor in ..board set...too much noise and erratic vibration
  Help a Brother Out Using 2 Tudor Motors...need to steady vibration and quiet motors. 
|
|
#2
06-11-2009, 10:53 AM
|
||||
|
||||
Good pictures
Not an expert but looks like thhe motors are in upsidedowm
|
|
#3
06-11-2009, 10:54 AM
|
||||
|
||||
|
Try this
KC try using some JB Weld or bracket the motor to the board from the woode frame. Lowes has the brackets to hold the motor up. If I can find a pic I'll post it. But ry the Weld first it should work.
Darrian
|
|
#4
06-11-2009, 11:00 AM
|
||||
|
||||
|
use the tape you have to secure it in place all around it.
wrap plummers tape around your screw and if you don't have a washer, use more tape for snug fit... that's what I would try........
|
|
#5
06-11-2009, 11:06 AM
|
||||
|
||||
|
WHAT THE?
MAN IT LOOKS A MESS UNDER THERE
NAH USE THE INFO ALL THE OTHERS HAVE OFFERED...YOU TOOK THE ROUGH ROUTE
__________________
"Do not go where the path may lead, go instead, where there is no path and leave a trail." http://www.leaguelineup.com/welcome.asp?url=bamfl
|
|
#6
06-11-2009, 02:59 PM
|
||||
|
||||
lol...I will stain and wood putty up the chopped wood sections...
need to get the running motor/vibration science to work
More work than anticipated.....but...I build mon..science is never simple...I am learning But I must finish it Quote:
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
