distance between players and start positions ?

[detroitchild]

I'll try to help Dmitri. See response below.

Originally Posted by the french guy

I bump this topic, because even with the help I received, the placing sequence stills not clear.

in the MFCA ruleset , we read :




and a few lines behind :




so if I understand correctly, we have :

1 - offense formation setup : straight lined figs
I don't know what you mean by "straight lined figs" but the entire offense sets up first.
2 - defense formation setup : straight lined figs
This is correct.
3 - O linemen pivots/angles
This is where it gets a little sticky. Normally the O linemen are not allowed to angle or pivot but some coaches or leagues allow it. I believe the MFCA rules don't allow it but you make the call here.
4 - all the defense squad can pivot and angle too
Not at this point. After initial set up the defense is considered "set" until...
5 - offense running backs and QB pivots/angles
Correct. After offense AND defense have determined their initial setups the offense can pivot or motion a pre-determined number of players, usually the QB, running backs, receivers AND tight end. Most leagues only allow up to 2-3 motions or pivots per play.
6 - defense pivots and angles as many figures as offense did in stage 5
Correct.
7- board on


DO I understand correctly the formation/placing sequence ?

Another question : what about the wide recievers and tight ends pivots ?
See # 5 above.

Keep in mind that the MFCA ruleset is a guideline to get you started. You can then modify those rules to your liking or move on to a more advanced style of play/rule set. Stay tuned for that.

thanks for your help


dimitri