|
|
|
#1
08-20-2008, 11:09 PM
|
|||
|
|||
Help!!
I just purchased some various bases from miggle. I started trying to tweak a few ttc bases. I started by flashing with no good results. I then would just slightly squeeze the prongs. The base would simply arc in a circle imediately left or right. I have tried to tweak 5 of these bases and I have spent an hour on some of them. I lost all 5 bases. I am not a beginning tweaker, but I am not getting anywhere with these bases. I have tried almost everything but cannot get anything out of these bases. Can anyone help??
|
|
#2
08-21-2008, 07:54 AM
|
||||
|
||||
|
tweaking
I am new to tweaking but I experienced same problems. I had a few gentlemen tell me that since I was new that it might've been how I was going about it and I agree. After reading you experienced same thing I did I feel much better that it is the bases , or part of the bases. I do thank all the guys up here for their help !
|
|
#3
08-21-2008, 11:09 AM
|
||||
|
||||
|
Bases
What bases were they?I know TTC but what color also.
__________________
So what I like to run 5 wide.What you gonna do about it.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
